High-temperature superconductivity in cuprates emerges out of a highly enigmatic pseudogap'metal phase. The mechanism of high-temperature superconductivity is probably encrypted in the elusive relationship between the two phases, which spectroscopically is manifested as Fermi arcs - disconnected segments of zero-energy states - collapsing into d-wave point nodes upon entering the superconducting phase. Here, we reproduce this distinct cuprate phenomenology in the 5d transition-metal oxide Sr 2 IrO 4 . Using angle-resolved photoemission, we show that the clean, low-temperature phase of 6-8% electron-doped Sr 2 IrO 4 has gapless excitations only at four isolated points in the Brillouin zone, with a predominant d-wave symmetry of the gap. Our work thus establishes a connection between the low-temperature d-wave instability and the previously reported high-temperature Fermi arcs in electron-doped Sr 2 IrO 4 (ref.). Although the physical origin of the d-wave gap remains to be understood, Sr 2 IrO 4 is the first non-cuprate material to spectroscopically reproduce the complete phenomenology of the cuprates, thus offering a new material platform to investigate the relationship between the pseudogap and the d-wave gap.

A superconducting transition temperature (Tc) as high as 100 K was recently discovered in one monolayer FeSe grown on SrTiO3. The discovery ignited efforts to identify the mechanism for the markedly enhanced Tc from its bulk value of 8 K. There are two main views about the origin of the Tc enhancement: interfacial effects and/or excess electrons with strong electron correlation. Here, we report the observation of superconductivity below 20 K in surface electron-doped bulk FeSe. The doped surface layer possesses all the key spectroscopic aspects of the monolayer FeSe on SrTiO3. Without interfacial effects, the surface layer state has a moderate Tc of 20 K with a smaller gap opening of 4.2 meV. Our results show that excess electrons with strong correlation cannot induce the maximum Tc, which in turn reveals the need for interfacial effects to achieve the highest Tc in one monolayer FeSe on SrTiO3.

The superconducting transition temperature (T_C) in a FeSe monolayer on SrTiO₃ is enhanced up to 100 K (refs ,,,). High T_C is also found in bulk iron chalcogenides with similar electronic structure to that of monolayer FeSe, which suggests that higher T_C may be achieved through electron doping, pushing the Fermi surface (FS) topology towards leaving only electron pockets. Such an observation, however, has been limited to chalcogenides, and is in contrast to the iron pnictides, for which the maximum T_C is achieved with both hole and electron pockets forming considerable FS nesting instability. Here, we report angle-resolved photoemission characterization revealing a monotonic increase of T_C from 24 to 41.5 K upon surface doping on optimally doped Ba(Fe_1-xCo_x)₂As₂. The doping changes the overall FS topology towards that of chalcogenides through a rigid downward band shift. Our findings suggest that higher electron doping and concomitant changes in FS topology are favourable conditions for the superconductivity, not only for iron chalcogenides, but also for iron pnictides.

Our study aimed to examine psychometric properties and cross-cultural utility of the Behavior Assessment System for Children-2, Parent Rating Scale-Child (BASC-2 PRS-C) in Korean children.Two study populations were recruited: a general population sample (n

The nematic phase in iron based superconductors (IBSs) has attracted attention with a notion that it may provide important clue to the superconductivity. A series of angle-resolved photoemission spectroscopy (ARPES) studies were performed to understand the origin of the nematic phase. However, there is lack of ARPES study on LaFeAsO nematic phase. Here, we report the results of ARPES studies of the nematic phase in LaFeAsO. Degeneracy breaking between the [Formula: see text] and [Formula: see text] hole bands near the [Formula: see text] and M point is observed in the nematic phase. Different temperature dependent band splitting behaviors are observed at the [Formula: see text] and M points. The energy of the band splitting near the M point decreases as the temperature decreases while it has little temperature dependence near the [Formula: see text] point. The nematic nature of the band shift near the M point is confirmed through a detwin experiment using a piezo device. Since a momentum dependent splitting behavior has been observed in other iron based superconductors, our observation confirms that the behavior is a universal one among iron based superconductors.

The FeSe nematic phase has been the focus of recent research on iron-based superconductors (IBSs) due to its unusual properties, which are distinct from those of the pnictides. A series of theoretical/experimental studies were performed to determine the origin of the nematic phase. However, they yielded conflicting results and caused additional controversies. Here, we report the results of angle-resolved photoemission and X-ray absorption spectroscopy studies on FeSe detwinned by a piezo stack. We fully resolved band dispersions with orbital characters near the Brillouin zone (BZ) corner, and revealed an absence of any Fermi pocket at the Y point in the 1-Fe BZ. In addition, the occupation imbalance between dxz and dyz orbitals was the opposite of that of iron pnictides, consistent with the identified band characters. These results resolve issues associated with the FeSe nematic phase and shed light on the origin of the nematic phase in IBSs.

The Muon Ionization Cooling Experiment (MICE) will perform a detailed study of ionization cooling to evaluate the feasibility of the technique. To carry out this program, MICE requires an efficient particle-identification (PID) system to identify muons. The Electron-Muon Ranger (EMR) is a fully-active tracking-calorimeter that forms part of the PID system and tags muons that traverse the cooling channel without decaying. The detector is capable of identifying electrons with an efficiency of 98.6%, providing a purity for the MICE beam that exceeds 99.8%. The EMR also proved to be a powerful tool for the reconstruction of muon momenta in the range 100-280 MeV/c.

The international Muon Ionization Cooling Experiment (MICE) will perform a systematic investigation of ionization cooling with muon beams of momentum between 140 and 240 MeV/c at the Rutherford Appleton Laboratory ISIS facility. The measurement of ionization cooling in MICE relies on the selection of a pure sample of muons that traverse the experiment. To make this selection, the MICE Muon Beam is designed to deliver a beam of muons with less than ∼1% contamination. To make the final muon selection, MICE employs a particle-identification (PID) system upstream and downstream of the cooling cell. The PID system includes time-of-flight hodoscopes, threshold-Cherenkov counters and calorimetry. The upper limit for the pion contamination measured in this paper is fπ < 1.4% at 90% C.L., including systematic uncertainties. Therefore, the MICE Muon Beam is able to meet the stringent pion-contamination requirements of the study of ionization cooling.

A novel single-particle technique to measure emittance has been developed and used to characterise seventeen different muon beams for the Muon Ionisation Cooling Experiment (MICE). The muon beams, whose mean momenta vary from 171 to 281 MeV/c, have emittances of approximately 1.2-2.3 π mm-rad horizontally and 0.6-1.0 π mm-rad vertically, a horizontal dispersion of 90-190 mm and momentum spreads of about 25 MeV/c. There is reasonable agreement between the measured parameters of the beams and the results of simulations. The beams are found to meet the requirements of MICE. © 2013 The Author(s).

A measurement of vector boson (V) production in conjunction with a D∗(2010)+ meson is presented. Using a data sample corresponding to 9.7 fb-1 of proton-antiproton collisions at center-of-mass energy s=1.96 TeV produced by the Fermilab Tevatron, we reconstruct V+D∗+ samples with the CDF II detector. The D∗+ is fully reconstructed in the D∗(2010)+→D0(→K-π+)π+ decay mode. This technique is sensitive to the associated production of vector boson plus charm or bottom mesons. We measure the ratio of production cross sections σ(W+D∗)/σ(W)=[1.75±0.13(stat)±0.09(stat)]% and σ(Z+D∗)/σ(Z)=[1.5±0.4(stat)±0.2(stat)]% and perform a differential measurement of dσ(W+D∗)/dpT(D∗). Event properties are utilized to determine the fraction of V+D∗(2010)+ events originating from different production processes. The results are in agreement with the predictions obtained with the pythia program, limiting possible contribution from non-standard-model physics processes.