Recent advances of ambient pressure X-ray photoelectron spectroscopy (AP-XPS) have enabled the chemical composition and the electrical potential profile at a liquid/electrode interface under electrochemical reaction conditions to be directly probed. In this work, we apply this operando technique to study the surface chemical composition evolution on a Co metal electrode in 0.1 M KOH aqueous solution under various electrical biases. It is found that an ∼12.2 nm-thick layer of Co(OH)₂ forms at a potential of about -0.4 V_Ag/AgCl, and upon increasing the anodic potential to about +0.4 V_Ag/AgCl, this layer is partially oxidized into cobalt oxyhydroxide (CoOOH). A CoOOH/Co(OH)₂ mixture layer is formed on the top of the electrode surface. Finally, the oxidized surface layer can be reduced to Co⁰ at a cathodic potential of -1.35 V_Ag/Cl. These observations indicate that the ultrathin layer containing cobalt oxyhydroxide is the active phase for oxygen evolution reaction (OER) on a Co electrode in an alkaline electrolyte, consistent with previous studies.

We report a new method to probe the solid-liquid interface through the use of a thin liquid layer on a solid surface. An ambient pressure XPS (AP-XPS) endstation that is capable of detecting high kinetic energy photoelectrons (7 keV) at a pressure up to 110 Torr has been constructed and commissioned. Additionally, we have deployed a "dip &pull" method to create a stable nanometers-thick aqueous electrolyte on platinum working electrode surface. Combining the newly constructed AP-XPS system, "dip &pull" approach, with a "tender" X-ray synchrotron source (2 keV-7 keV), we are able to access the interface between liquid and solid dense phases with photoelectrons and directly probe important phenomena occurring at the narrow solid-liquid interface region in an electrochemical system. Using this approach, we have performed electrochemical oxidation of the Pt electrode at an oxygen evolution reaction (OER) potential. Under this potential, we observe the formation of both Pt(2+) and Pt(4+) interfacial species on the Pt working electrode in situ. We believe this thin-film approach and the use of "tender" AP-XPS highlighted in this study is an innovative new approach to probe this key solid-liquid interface region of electrochemistry.

We fabricate a field-effect transistor by covalently functionalizing PbS nanoparticles with tetrathiafulvalenetetracarboxylate. Following experimental results from cyclic voltammetry and ambient-pressure X-ray photoelectron spectroscopy, we postulate a near-resonant alignment of the PbS 1Sh state and the organic HOMO, which is confirmed by atomistic calculations. Considering the large width of interparticle spacing, we observe an abnormally high field-effect hole mobility, which we attribute to the postulated resonance. In contrast to nanoparticle devices coupled through common short-chained ligands, our system maintains a large degree of macroscopic order as revealed by X-ray scattering. This provides a different approach to the design of hybrid organic-inorganic nanomaterials, circumvents the problem of phase segregation, and holds for versatile ways to design ordered, coupled nanoparticle thin films.

The role of the interface between a metal and oxide (CeOx-Cu and ZnO-Cu) is critical to the production of methanol through the hydrogenation of CO2 (CO2 + 3H2 → CH3OH + H2O). The deposition of nanoparticles of CeOx or ZnO on Cu(111),oxi < 0.3 monolayer, produces highly active catalysts for methanol synthesis. The catalytic activity of these systems increases in the sequence: Cu(111) < ZnO/Cu(111) < CeOx/Cu(111). The apparent activation energy for the CO2 → CH3OH conversion decreases from 25 kcal/mol on Cu(111) to 16 kcal/mol on ZnO/Cu(111) and 13 kcal/mol on CeOx/Cu(111). The surface chemistry of the highly active CeOx-Cu(111) interface was investigated using ambient pressure X-ray photoemission spectroscopy (AP-XPS) and infrared reflection absorption spectroscopy (AP-IRRAS). Both techniques point to the formation of formates (HCOO-) and carboxylates (CO2δ-) during the reaction. Our results show an active state of the catalyst rich in Ce3+ sites which stabilize a CO2δ- species that is an essential intermediate for the production of methanol. The inverse oxide/metal configuration favors strong metal-oxide interactions and makes possible reaction channels not seen in conventional metal/oxide catalysts.

Operando synchrotron radiation photoelectron spectroscopy in the tender X-ray energy range has been used to obtain information on the energy-band relations of semiconductor and metal-covered semiconductor surfaces while in direct contact with aqueous electrolytes under potentiostatic control. The system that was investigated consists of highly doped Si substrates that were conformally coated with ∼70 nm titania films produced by atomic-layer deposition. TiO2/electrolyte and Si/TiO2/Ni/electrolyte interfaces were then analyzed by synchrotron radiation photoelectron spectroscopy. The PES data allows for determination of the flat-band position and identification of potential regions in which Fermi level pinning, depletion, or accumulation occurred. Operando X-ray absorption spectroscopy (XAS) techniques were additionally used to investigate the properties of heterogeneous electrocatalysts for the oxygen-evolution reaction. Operando XAS including the pre-edge, edge and EXAFS regions allowed the development of a detailed picture of the catalysts under operating conditions, and elucidated the changes in the physical and electronic structure of the catalyst that accompanied increases in the applied potential. Specifically, XAS data, combined with DFT studies, indicated that the activity of the electrocatalyst correlated with the formation of Fe dopant sites in γ-NiOOH.

The electrical and spectroscopic properties of the TiO2/Ni protection layer system, which enables stabilization of otherwise corroding photoanodes, have been investigated in contact with electrolyte solutions by scanning-probe microscopy, electrochemistry and in-situ ambient pressure X-ray photoelectron spectroscopy (AP-XPS). Specifically, the energy-band relations of the p+-Si/ALD-TiO2/Ni interface have been determined for a selected range of Ni thicknesses. AP-XPS measurements using tender X-rays were performed in a three-electrode electrochemical arrangement under potentiostatic controlto obtain information from the semiconductor near-surface region, the electrochemical double layer (ECDL) and the electrolyte beyond the ECDL. The degree of conductivity depended on the chemical state of the Ni on the TiO2 surface. At low loadings of Ni, the Ni was present primarily as an oxide layer and the samples were not conductive, although the TiO2 XPS core levels nonetheless displayed behavior indicative of a metal-electrolyte junction. In contrast, as the Ni thickness increased, the Ni phase was primarily metallic and the electrochemical behavior became highly conductive, with the AP-XPS data indicative of a metal-electrolyte junction. Electrochemical and microtopographical methods have been employed to better define the nature of the TiO2/Ni electrodes and to contextualize the AP-XPS results.

Photoelectrochemical water splitting is a promising pathway for the direct conversion of renewable solar energy to easy to store and use chemical energy. The performance of a photoelectrochemical device is determined in large part by the heterogeneous interface between the photoanode and the electrolyte, which we here characterize directly under operating conditions using interface-specific probes. Utilizing X-ray photoelectron spectroscopy as a noncontact probe of local electrical potentials, we demonstrate direct measurements of the band alignment at the semiconductor/electrolyte interface of an operating hematite/KOH photoelectrochemical cell as a function of solar illumination, applied potential, and doping. We provide evidence for the absence of in-gap states in this system, which is contrary to previous measurements using indirect methods, and give a comprehensive description of shifts in the band positions and limiting processes during the photoelectrochemical reaction.

Inorganic nanocomposites synthesized by combination of colloidal nanocrystals (NCs) and inorganic clusters have recently emerged as new materials with novel and unique functionalities. Much of the demonstrated promise of nanocomposites derives from the unique interactions between NC and matrix components - this generates new material properties, which direct unique transport behavior in the overall solid or nanocomposite - be it mass, charge, or heat. While measured empirically, it has remained largely impossible to take an a priori look at material properties and use those as a guideline to design desired transport behavior. Fundamentally, this is because the structural and electronic changes manifest at those interfaces have remained hidden from examination. Here, we provide experimental evidence that transport behavior in nanocrystal-in-matrix (NIM) composites is dictated primarily by interfacial charge transfer associated with electronic and structural reconstructions as the composite forms. Our approach building continuous composite superlattices serves as a starting point for systematic probing of the nanointerface of NIM composites via ultrathin films. A combination of field effect transistor device characterization and photoemission spectroscopy reveals the systematic dependence of the polarity of charge transfer on the selection of matrix materials in NIM composites. We use this insight to combine, by design, different components to tune the carrier type in NIM composites.